Sotnikov

Rated 2.80(5) — Sotnikov

This is a test for attention and observation.Find on the table a sequence of pairs of blue and red numbers from 1 to 51.If you can find these numbers in: 5-10 minutes, you have excellent attention 10-15 minutes - good 15-20 minutes - average 20-25 minutes

Rated 3.00(1) — Sotnikov

The calculator counts the the total flat length according to the K-factor you specify.If you do not know the value of K-factor, then the program, determining the the total flat length, depending on the method of bending and stiffness of the material...

Rated 4.70(150) — Sotnikov

Calculator will calculate the necessary dimensions for the construction flat pattern segments bend , tee piece, frustum cone and truncated pipe.Calculation flat pattern used as a template for cutting the pipe, producing with wall thickness s = 0.

Rated 4.64(664) — Sotnikov

The flat pattern of a cone is an application that calculates the parameters for a development of a right, oblique or truncated cone.For creating a cone from sheet metal or any flat material.

Rated 4.67(15) — Sotnikov

The calculator allows to define the theoretical mass of reinforcing bars steel grid of circular cross-section with a constant pitch of the bars in the longitudinal and transverse directions.

Rated 4.00(1) — Sotnikov

The application calculates the volume and weight of a liquide by its filling level, empty and total volume.Calculations are performed for:- Rectangular tank- Horizontal cylindrical tank- Vertical cylindrical tank- Cylindrical tank with conical bottom-...

Rated 5.00(1) — Sotnikov

The application allows to calculate the length of a work piece for bending of metal sheets or stripes, round or square bars and round tubes.No advertising.

Rated 4.67(6) — Sotnikov

Calculator will calculate the necessary dimensions for the construction flat pattern segments bend , tee piece, frustum cone and truncated pipe.Calculation flat pattern used as a template for cutting the pipe, producing with wall thickness s = 0.

Rated 5.00(1) — Sotnikov

The flat pattern of a cone is an application that calculates the parameters for a development of a right, oblique or truncated cone.For creating a cone from sheet metal or any flat material.

Rated 4.42(393) — Sotnikov

The application allows to calculate the length of a work piece for bending of metal sheets or stripes, round or square bars and round tubes.

Rated 4.12(17) — Sotnikov

Schulte table is a table in which the cells chaotically placed certain information (usually in series of walking). The most common kind of interpretation Schulte table - a square array that has 5 columns and 5 rows, which randomly placed numbers from...

Rated 4.57(954) — Sotnikov

The application calculates the volume and weight of a liquide by its filling level, empty and total volume.Calculations are performed for:- Rectangular tank- Horizontal cylindrical tank- Vertical cylindrical tank- Cylindrical tank with conical bottom-...