About NeonBlox
The aim of the game is to get the block to fall into the square
hole at the of each stage.
there are 33 stages to complete.
To move the block around the world use arrow key.
Be careful not to fall off the edges
the level will be restarted if this happens.
Bridges and switches are located in many levels. The
switches are activated when they are pressed down by
the block.
You do not need to stay resting on the
swicth to keep bridges closed.
There are two types of switches:
heavy x-shaped and soft round ones
Soft switches are activated when any part of your
block presses it.. Hard switches require much more
pressure, so you block must be standing on its and to
activate it.
When activated, each switch may behave differently.
Sme will swap the bridges from open
to closed to open each time it is used.
Some will only ever make certain bridges open,
and activating it again will not make it
close.
Green or red coloured squares will flash
to indicate which bridges are being operated.
Orange tiles are more fragile than the rest of land.
If your block stands up vertically on an orange tile, tile give
way and your block will fail.
Finally there is a third type of switch shaped like this ( )
It teleports your block to different locations,
splitting it into two smaller blocks at the same time.
These can be controlled individually and will rejoin
into a normal block when both are place next to each other.
you can select which small block to use at any time
by pressing the space barr.
Small blocks can still operate soft switches,
but they aren't big enough to activate heavy switches. Also small blocks cannot go
through the exit hole - only a complete block
can finish the stage.