Smart plummet Free

The program is designed to measure the angle of near to vertical object edges. The main feature of the program is an ability to automatically capture and hold the edges of the measured objects or lines for more accurate measurements.

Note: It's possible to use the program without calibration, but we advice you to make both calibrations for more accurate results.

Calibration procedure of g-sensor:

1. Menu options -> "Sensor calibration".
2. Place the device vertically on it's edge as shown in the hint on the screen.
3. Turn the device sequentially at each edge, waiting each time for the blue stripes on the edge of the screen to appear.
4. Put the device horizontally face down, then flip it the screen up.


Setting the true vertical:

1. Long touch screen with your finger until "Long touch again to set true vertical" label appears.
2. Target the camera to a plumb (or any other true vertical edge). Wait until this edge is "Stably" "Locked", and carefully long touch again trying not to shake the device.

Using the program:

We tried to make program's interface as intuitive as possible. And we hope that you'll have no difficulties using the program.