Redirector TCP_SerPort

The program is a redirector that takes the data from the network (TSP), and forwards them via the serial port connected to Android on various devices, the data from the COM port are sent to the network. Compatible Adapter USB <-> COM and devices on chips FT232RL (FTDI), CP2102 (Silicon Lab), PL2303 (PROLIFIC). Android must have USB HOST and version 3.1 or
Where it may be used? Let's say you have a device (such as a microcontroller board ARDUINO, etc.) that has a USB or RS232 interface and works with kompyuterom.Vam need to get data from it or control it over a network or the Internet.
It often happens that rewrite the program on the computer to the network is not possible (difficult, there is no "source", etc.) and to alter the controller on the network too often prosto.Vyhod be takoy.K Android via an adapter USB <> COM or directly (if the device has USB) connected devices. On your computer, run this program
HW Virtual Serial Port Single (can be found in the internet) that creates a virtual COM port to the system and redirects the data over the network to Android. Run the program TCP_SerPort on Android. In the VSP program on the computer and specify the IP port (3333) android device.
Run the program that operates the connected equipment on the PC and connect to the virtual COM port created by the program VSP. Everything. We work with the device can be used for seti.Takzhe Android device as a WIFI hotspot and connect to it over WIFI. To work with the device via the Internet to the router perkinut port 3333 on Android device.

A soft-analogue programs wonderful tool LINUX ser2net. There are programs redirectors for the PC, but they are mostly paid on both sides should be computers that are often uncomfortable. There is so much the same "iron" type solutions Tibbo. Plus the use of Android is that small, we immediately have WI_FI and can even organize the processing and data entry.

Redirector can also be used in robotics when android device is on a cart, and rulim removed from a PC or other androida.Dlya this just write TCP client to the server. So it is possible to connect different business equipment (scanners, printers, etc.)

The program Veta versiya.Zamechaniya welcome. Before use, you can check whether you are working on a device adapter USB <> COM TermUSB.Vnimanie my program! If you have a device with Android> = 3.1 and USB HOST and Adaptors USB COM are not necessary to include USB HARDWARE
[
# Unmount system
mount-o remount, rw / system
# Create a file android.hardware.usb.host.xml in / system / etc / permissions
# Write it



# Open in the / system / etc / permissions file called
# Tablet_core_hardware.xml and add to it
  in section
]

So, I recommend to test the program on a network this utility Hercules Setup UTILITY.
And of course in LINUX NETCAT