ESP8266 smart switch for Android
June 14 2015 Update: Got it to control the relay on the esp8266 test board by turning all dip switches on the left near the power connector off and the dip switch settings on the right ar as follows: on-off-on-0ff-on-off. Then jumper gpio14 to gpio2 just below the dip switch. You now can control the relay. Wow...after a little research , trial and error I got it to work!!!!! Thanks. Make sure you do exactly what it says. Files needed on the link down on the bottom: On the secound download make sure you change the program address offset hex exactly as he has it - this was my main problem. ox40000 and it works great. Now I can control relays and stuff with buffers. The links to his page is all you need - all the info is there . New update works great. Button lights up green when comfirmed by esp8266. Also reverse mode is a plus. Click in the link " visit website" to get all the info needed.
Utility opens but not getting connected. It counts till 200 and returns "failure to connect to target". Would be helpful if this gets sorted out.
Connection
Loading is ok with 00000 but not 40000. While configuring the device after a flash from else where ,pressing the open button it shows ok. but while pressing connect it fails though it counts 200.It but perfectly identified the IP of the phone and the device.
You have done a great work. But it will be nice if you make it open source.. A community support can make it a more great app. I'm also making a dimming and switching application with esp.
Wow...after a little research , trial and error I got it to work!!!!! Thanks. links to get it to work: http://tskit.co.kr/zbxe/download/2587 make sure you do exactly what it says. Files needed on the link down on the bottom: http://tskit.co.kr/zbxe/?module=file&act=procFileDownload&file_srl=2588&sid=a215946cfabbeb4f9842f737171da42d the utility software for the serial comm port download: http://tskit.co.kr/zbxe/?module=file&act=procFileDownload&file_srl=2598&sid=de0b39f9eed0df28363437f0e363fea2 On the secound download make sure you change the program address offset hex exactly as he has it - this was my main problem. ox40000 and it works great. Now I can control relays and stuff with buffers. This page is all you need - all the info is here .
At all
by K####:
Quickest I've ever uninstalled an App