YOKIS-PRO

With a YOKEY (Code 5454491) you can use your Tablet (with OTG port) to create and edit your sites and make them evolve with a simple touch of your finger.
You can use the YOKIS PRO app to:
• create a plan of the home
• automatically detect V5 version green modules
• position the modules on the plan and identify junction boxes
• automatically create and optimise the YOKIS ‘Radio bus’ among the modules present
• simply add, configure and duplicate the radio control points
• define Scenes (back home, away for the weekend, etc.) when to start Scenarios, either manually (from remote control) or automatically (following Time events or other).
• save and share your sites in protected mode on the Yokis Cloud
• transfer and configure the site on the Yokis Hub (Code 5454495) and consequently allow end users to control their homes using the YnO app (available soon)

#### Other features of the 1.4.1 version ####

### Updating YOKEY and V5 Module/Transmitter software
--> When the YOKEY is connected, the app checks if it is updated to the latest version. If this is not so, it will update it automatically. Important: the update may take a few minutes, do not interrupt.
--> The V5 modules and transmitters are automatically updated to the last available version. The update is performed during the module scan or during transmitter configuration.

### Creating home maps:
--> Simply draw the perimeter to define a room: the inner part will be filled automatically.
--> The Zoom instrument can be used to zoom in and out of the map.

### Managing buildings:
--> Creating and editing sites including several apartments
--> Duplicating an apartment (completely or partially)
--> Generating a single summary document for the entire building

### Creating Scenes:
--> Scenes can be created once a hub has been detected in the YOKIS PRO app (the Scenes pushbutton (step 3) turns active).
Each Scene includes:
- a Scenario, i.e. a set of modules which assume a given state or condition
- one or more Events which ‘trigger’ the Scenario
Scenario:
- Multiple modules (up to 255) are grouped in a Scenario.
- The state of the module when the Scenario is triggered (light on, blinds down, etc.) can be defined for each module of the Scenario
A Scenario may be triggered by one or more Events.
Events:
These are used to ‘trigger’ the Scenario. There may be more than one. They may be manual or automatic.
- Manual events
> Pressing a remote control pushbutton
- Automatic events:
> Only once, at a specific Date and Time
> Periodically on a weekly basis
> At sunrise or sunset
> Following a change of state in some modules

## Managing V4 version products (grey modules and V4 transmitters):
--> V4 modules can be added in manual scan mode (1 pressing of the manual scan pushbutton in the app + pressing of the “Connect” pushbutton on each V4 module)
--> Configuration of V4 radio receivers (grey modules) by the app
--> Creation of the YOKIS radio bus directly in the app by selecting all the modules to be connected
--> Configuration of the V4 radio transmitters
--> Management of the V4 modules also in the YnO control app (available soon)

### Other
--> The receiver duplication function can be accessed in the ‘Connections’ section. Available for V5 and V4 modules. Additionally, this can be used to control multiple dimmers in parallel to operate high power loads.