InstElectric

Tool to support the calculation of electrical installations.

· Dimensioning of low voltage circuits with the most frequent installation methods
· Calculation of cable phase size, neutral, protective conductor, nominal protection current, voltage drop
· Calculation criteria depending on the permissible current of the cable, permissible voltage drop and protection against overcurrent
· Calculation of the diameter and designation of the conduit
· Designation of most commonly used insulated cables / conductors
· Circuits with circuit breaker until to In = 4000 A (Ir setting = 0.4 to 1 x In), maximum fuse In = 1600 A (gG type), maximum 12 conductors parallel per phase, maximum size 630 mm²
· Estimation of the maximum short-circuit current (approximate method)
· Forecast of loads of a building destined to houses with several sections: dwellings, common services, commercial premises/offices and garage with/without infrastructure for recharging electric vehicles
· Reactive power of the capacitor bank for the compensation of the power factor (cos φ) and capacity (µF) of the capacitors
· Choice of installation system in the function of the circuit, cable and its situation
· Calculation of the electricity parameters of a single-phase or three-phase (balanced)
· Power in an unbalanced three-phase system
· Overvoltages due to loss of neutral conductor, earth fault and short circuit

· Configuration of constants (voltages, conductivity, temperatures, etc.) that affect electrical calculations
· Adjusting the protections (circuit breakers and fuses)
· Selection of minimum gauge for circuit-breakers with regulation and maximum cable size for multi-conductor grouping per phase
· Selection of the calculation method estimation of the reactance
· Conductivity of the conductor depending on the current of the circuit (constant, according to the expected current, maximum cable temperature)
· Use reduction factors by grouping cables/circuits
· Use of factors of diversity/utilization

· Reference documents: IEC Standards, Reglamento Electrotécnico para Baja Tensión (REBT), Technical Application Guide, RD 1053/2014, (UE) 2016/364

The user of the application (designer / electrician) will be able to make calculations easily and quickly for the dimensioning of the electrical installation or on-site checks

IN NO CASE SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT OR INDIRECT DAMAGES AS A RESULT OF THE CORRECT OR INCORRECT USE OF THE APPLICATION