BHP Monitor For Torque Beta

*IMPORTANT, This is a plugin for Torque Pro and will not function as a standalone app*

Please do contact me if bugs on the plugin is found.

Ever wanted to log using Torque Pro as if it was running on a dyno ?

Showing results such as peak horsepower and torque on the rpm it was achieved ?

Well look no further, this plugin does the following.
- [NEW] Dynographer by Gear
- Allows the user to find out at which specific rpm was the horsepower / torque produced.
- *Street friendly as it only takes the highest values of horsepower / torque from your runs.
- Allows minimum rpm trigger for plugin activation as such preventing low horsepower readings which are totally off the power band of your vehicle.
- Transmission loss factor can be also adjusted in the settings
- In addition to the transmission loss factor you may fine tune the plugin along with Torque Pro with BHP Correction Error Factor allowing two factor modifications for an accurate reading.
- Custom entry of speed time attacks, such as 0-X (X Being the custom value you have set defaulted to 100) kmph / mph. (It's separate for both types in a sense allowing 2 readings if converted in-between the values.)
- Time attack maximum activation speed, allows the user to select a maximum speed barrier when launching the vehicle instead of the usual 0 kmph start.
- Monitors the commonly available (in Torque) essential functions of the engine through Torque Pro such as Coolant Temp, Engine RPM , Intake Air Temp and Timing Advance.

*Assuming that your driving safely / doing it on a track.