Wellness health monitor

The "Wellness Health Monitor" program was created to improve safety in relaxation areas of wellness centers and vital worlds. The program cooperates with the control system VAMELI RMV4 from which it receives information from safety buttons located in saunas and cabins. It can also communicate with a different parent system if the necessary XML control commands are programmed into it. Using security buttons installed in the cabins, people can report their health issues, which may occur in these areas, to the operating staff. The process works as follows: by pressing a button connected to a control unit RMV4 (or a different parent system), which is located in the cabin, the information is transmitted to an information board, preferably an Android tablet. A tablet has to be connected to a common network with control units RMV4 via WiFi. Information obtained from buttons in the cabins is then transferred through this network to the tablet. This is how the program informs the operating stuff which can then immediately react to the situation. After pressing a security button in the cabin, the connected tablet beeps. The pressed button in the cabin will turn red. During the state of preparedness, this red LED light in the button flashes every 5 seconds to indicate that the button is functional. To deactivate the warning signal, the operating stuff needs to push the red button of a corresponding alarm on the information panel display. The button, which was used to deactivate the alarm, displays number of active alarms.