iMatic

It does surprisingly work in landscape on my Android head unit.yet my phone only does portrait mode. Not major issue but nearly didn't buy the product cause I tested the app on my phone looking for landscape mode for my head unit which wasn't as easy to get to at the moment. It runs to my needs at the moment. Given the known bugs I'd rate a 3, open source code made it a 4

Whenever I open the app it turn ON all the relays automatically. It should read the status of board first and then tell the person that these relays are in ON condition and these are in OFF condition. please help.

The card is connected with the default port and pings but the app keep on saying to check the network. It's an annoying bug.

The hardware board is perfect. The app has a serious flaw. If you turn off then on the wifi on your phone, the app gives an error message. This error does not clear unless you cycle power to the board (even restarting the phone does not help). Very poor app design! The manufacturer sainsmart does not seem intent on fixing this problem even though they admitted the problem when I contacted them.

You should post a actual source code each time you're updating the app. In other case the hardware is not so attractive

Please include voice control option

Will not connect to board

Plsase add more options to app, like schedule.

The hardware board is perfect. The app has a serious flaw. If you turn off then on the wifi on your phone, the app gives an error message. This error does not clear unless you cycle power to the board (even restarting the phone does not help). Very poor app design! The manufacturer sainsmart does not seem intent on fixing this problem even though they admitted the problem when I contacted them.

Would like to see a "Non-latch" option for some relays.

New version doesn't connect to the device making it useless !! where can I download old version from ??

New version works great love the look and option to change IP I'm now able to control it with 4g by forwarding port 3000 on router

Utterly broken

You can not connect 2x clients to the unit at the same time, or it freezes up! (can not connect to service)

This app need some better looking interface

This App is no more than a set of 8 or 16 buttons to supposedly turn on and off as many relays. There are no settings, no instructions, and all it wants to do is direct you to a shop where you buy the board. The board is even worse. It expects your router to have IP 192.168.1.1 and it only uses the fixed 192.168.1.4. This is the worst configuration I have seen. I am expected to change my whole subnet configuration to accommodate one gadget? Ludicrous.