DIY Bracelet Craft Ideas for Android
The making of these bracelets requires your patience and great attention to details since you will be making lots of interlocking and overlapping layers of the ribbons to get the bracelet to turn out right. This tutorial is to show you how to make Boxed Stitch Ribbon Bracelets out of colorful ribbons that are inter-woven to form a colorful stretchy bracelet. To make Boxed Stitch Ribbon Bracelets , you need the following materials:
1.8 yards of grosgrain ribbons cut into four equal parts of 2 yards each. Ribbon can be either a 1/4 or 1/2 inch wide. (a) If you plan to use one color ribbon, get a full eight yard to be cut into 4 equal parts (2 yards each). (b) For a mix of two colors, get 4 yards of each color, then cut the 4 yards into 2 equal parts. (c) For a mix of four colors, get 2 yards of each color ribbon.
2.Scissor, to cut and trim ribbons and thread.
3.Sewing needle and thread, for sewing the finished ends together.
Once your ribbons are all cut to size and ready, then it's time to start overlapping and interlocking the ribbons.
To begin, first thing to do is to
• Lay all ribbons on a flat surface (see Image 1). Find the center point of the ribbons (about 36 inches through the middle) overlapping at center as shown (Image 1).
• Then glue ribbons where they overlap (at center) to keep ribbons from shifting/moving around. Use a light, clear fabric glue to keep ribbons from hardening up, or you can tack through with needle and thread, just enough to keep ribbons from shifting around. If you're using glue, give it time to dry. Once ribbons are in place (not shifting around), then, it's time to start interlocking the ribbons.
• To start interlocking the ribbon, using quad stitch pattern, overlay each strip of ribbon one after the other, looping the last piece of ribbon to lock all the stitches. (see accompanying video). Repeat the steps over and over again, making sure to go around once for each strip of ribbon until the ribbons stack up to about 8 inches long. At about 8 inches long of interlocked ribbons, bring the ends of the bracelet together and stitch with a threaded needle, securing all four sides. Trim off the excess ribbons.
The bracelet is now ready to wear. These type of bracelet do have a lot of stretching room and will fit most size wrist.
So, what are you waiting for? let's make your own cretaion of your bracelet design. Downloas this application and you will find step by step to make your bracelet.
DIY Bracelet Craft Ideas
Source of marvelous ida for your bracelet craf design!