Unique Wood Wall Hanging

American flag is a great country-style accent and shows your patriotism year-round.

Completion time – 2-4 hours

Materials
STYROFOAM Brand Foam
1- 1" x 24" x 36" sheet or 1- 1" x 12"x 36" sheet

Other Materials
44/45" wide cotton fabric:
1- 3/4yd. solid white
1- 9-1/2" x 12-3/4" solid denim blue
1- 1/3 yd.red bandana print, or red print of your
Thick white craft glue
1- 2-1/4 yd. of 7/8" light navy blue grosgrain rib
Sawtooth picture hanger and nails
8- round toothpicks or 2-1/2" floral picks with wi
Assortment of white buttons

Tools
Fine line permanent marker
Serrated steak knife
Candle stub or paraffin
Scissors
Putty knife with 1-1/2" blade, or a #10 artist's p
Sharp pencil
White chalk marking pencil
Low-temperature glue gun and glue sticks
Straight pins

Instructions
1. To make rectangle, wax blade of knife and cut two 12" x
16-1/4" lengths from 1"x 12"x 36" sheet. Glue two pieces
together along 16-1/4" edge, using glue and toothpicks between
pieces. If using a larger 1"x 24"x 36" sheet, mark and cut a
24" x 16-1/4" piece.

2. Refer to diagram and use ruler and fine permanent marker to
draw flag pattern on sheet of STYROFOAM™. Using ruler and sharp
pencil, score all lines.

3. Iron fabric and cut as follows:
bandanna print flag stripes:
4- 2" x 12-3/4"
3- 2" x 24-3/4"

solid white flag stripes:
3- 2" x 12-3/4"
3- 2" x 24-3/4"

denim blue field
1- 9-1/2" x 12-3/4"
solid white backing
1- 17" x 24-3/4"

4. To tuck wallhanging:
Begin with blue denim field.
b. Center fabric over appropriate scored design.
c. Position putty knife perpendicular to sheet of STYROFOAM™.
Place knife on scored line and push fabric seam allowance into
STYROFOAM™. Note: The tucking procedure works best when
standing.
d. Trim excess with scissors.
e. Tuck in stray fabric with tip of serrated knife.
f. Glue seam allowances to edge of sheet.

5. Tuck stripes in order, following numbers on diagram.

6. To cover back:
Center fabric over back of sheet and pin in place.
b. Glue seam allowances to edge of sheet.

7. Glue grosgrain ribbon around edge of sheet.

8. Glue hanger to center back of wallhanging about 1" below
top edge. Apply a small amount of glue to each of the two
small nails. Push nails through holes in hanger and into sheet.

9. Arrange buttons on blue field as desired; glue in place.

for further information and detail tutorial, download this application now and you will have what you want.
please enjoy this tutorial and give us any feedback.