Brain Sense

Brain Sense
The official HMI solution for the Genesense IOT embedded system.


The Genesense device features:
• 18 DBI Wi-Fi connections
• 2 Analog Input with 0-5V, 0-10V, 4-20mA user selection
• 2 digital inputs for counter and dry contact
• 2 relay output 220V 10Amp
• 1 PWM output
• 4 DS18b20 1 wire temp sensors
• 2 Temp/Hum sensors
• RTC build in with battery backup
• SD card interface for log storage
• Enclosure with screw terminal
• USB for power and programming (CH340)
• Battery power backup, sleep and deep sleep mode (2 years)
• Protocols: MQTT, SNMP, MODBUS, HTTP, HTTP POST
• Build in Web server for setup and monitoring
• Free SNMP/HTTP POST web server for up to 100 sensors
• Free MQTT broker and server

App Features:
• Works with Genesense series devices, as well as with any other Modbus device.
• Connects to the plc using the Modbus protocol over TCP/IP
• Reads from Input Status (Digital input), Input Register (Analog input)
• Reads and writes from Coils (Digital output), Holding Registers (Memory)
• Reads boolean, bit values, 16 bit / 32 bit integers.
• Supports multiple plc configurations
• Supports Input Register modifier formula (to alter sensor output)
• Highly configurable - you create and manage your plc's and addresses
• Reads values each 2 seconds from the plc to keep the information live on the screen
• 40 ms read time, 70 ms write time over local network
• A few dozen icons to customize your interface
• Material design

How it works:
The app connects to the Plc and can read/write values in and from the Modbus registers.

How to set it up:
• Install Brain Sense
• Set up your plc using the Ip and Port
• Two addresses will be created by default. See if the configuration works.
• Make sure to be on the same network with your plc or use static ip / port routing.
• Profit

Once configured, it's fast and reliable