About Somachine System Diagnostic
ENG:
The App Somachine System Diagnostic reads, via TCP / IP protocol Modbus, the registers from 60000 up to 60035 present in PLC [devices programmable with Somachine software]
With an access-point, connecting the Ethernet channel of the device to the wireless network.
Will be sufficient to know the IP address of the device, connect with the app (page LOG) and follow the instructions provided by the INFO page.
The application, identified the type of PLC that is connected, it will allow you to read the Identity of device (page IDY) and the Diagnostic device (page DIAG).
From REQ page you can read / write the values of the variables within the map data of the PLC.
This app not uses the option WebServer side plc then You can disable the WebServer option.
For this app is not necessary write application program in memory plc.
ITA:
L’App Somachine System Diagnostic legge, via TCP/IP protocollo Modbus, i registri dal 60000 al 60035 presenti nel PLC [Dispositivi programmati con il software Somachine]
Per mezzo di un access-point, collegare il canale Ethernet del plc alla rete wireless.
Sarà sufficiente conoscere l'indirizzo IP del device, connettersi con l'app (pagina LOG) e seguire le indicazioni fornite dalla pagina INFO.
L'applicazione identifica il tipo di PLC a cui è connessa, consentirà di leggere i dati Identificativi (pagina IDY) e la Diagnostica (pagina DIAG).
Dalla pagina REQ sarà possibile leggere/scrivere i valori delle variabili presenti all'interno della mappa dati del PLC.
Questa applicazione non utilizza l’opzione web Server e quindi può essere disabilitata.
Per questa applicazione non occorre scrivere alcun codice programma applicativo lato plc. ENG:
The App SoMachine System Diagnostic reads, via TCP / IP protocol Modbus, the registers from 60000 up to 60035 present in PLC [programmable devices with SoMachine software]
With an access-point, connecting the Ethernet channel of the device to the wireless network.
Will be sufficient to know the IP address of the device, connect with the app (page LOG) and follow the instructions provided by the INFO page.
The application, Identified the type of PLC That is connected, it will allow you to read the identity of the device (page IDY) and the Diagnostic device (page DIAG).
From REQ page you can read / write the values of the variables Within the map data of the PLC.
This app uses the option not WebServer side plc then You can disable the Web Server option.
For this app is not Necessary write application program in memory plc.
ITA:
The App SoMachine System Diagnostic law, via TCP / IP protocol Modbus registers 60,000 to 60,035 in the PLC [devices programmed with the SoMachine software]
By means of an access-point, connect the Ethernet channel of the plc to the wireless network.
Will be sufficient to know the IP address of the device, connect to the app (page LOG) and follow the instructions provided on page info.
The application identifies the type of PLC connected to it, will read the data identifiers (page IDY) and Diagnostics (DIAG page).
REQ from the page you can read / write variable values inside the map data of the PLC.
This application does not use the Web Server and therefore can be disabled.
This application does not need to write any code application program side plc.