機械手臂藍牙App

有買藍牙升級套件的請參考此步驟：

使用藍牙前要先跟手機配對，之後再打開meArm_bt APP，按下紅色藍牙圖示來跟藍牙連線，若有成功連線，則藍牙板上紅燈就長亮而不閃爍，而且APP上的藍­牙圖示也會變成藍色，這時就可用手機操控手臂了，結束時記得再按一次APP上的藍牙圖­示離線喔。之後每次開APP要操控手臂時就只要連線即可，不用再配對了。

註：

1．藍牙板為 HC﹣06，baurate 已調成 38400

2．腳位使用：RX／DX＝12／13 （在Arduino中就算上傳程式也不用拔掉藍牙卡）

3．若使用S4A，板上LED腳位為PIN4，否則為PIN3

4．欲安裝藍牙APP，請下載本步驟所附的 meArm_Joystick.apk Have to buy a Bluetooth upgrade kit, please refer to this procedure:

First paired with the phone using Bluetooth before, after and then open meArm_bt APP, press the red with a Bluetooth connection to the Bluetooth icon, if successful connection, the Bluetooth board without blinking red light on the long and on the APP Bluetooth icon will turn blue, then you can control the arm using a mobile phone, remember to press the Bluetooth icon offline Oh APP on end. After each time you want to manipulate the arm APP open for as long as you can connect, not matched right.

Note:

1. Bluetooth board for the HC-06, baurate been transferred into 38400

2. Pin Use: RX / DX = 12/13 (in the Arduino Uploader do not even unplug the Bluetooth card)

3. If you use S4A, panel LED pin is PIN4, otherwise PIN3

4. To install the Bluetooth APP, please download the attached meArm_Joystick.apk this step