通用藍牙資料繪圖器(Generic BT plotter)

此 App 為一小工具, 適合下列工程場合使用 :
- Double A project (Arduino + Android)
arduino 端當感測端(溫度, 濕度, 壓力 etc.) 然後將原始資料化成 0~~100 的資料透過藍牙模組送至 Android 端,
此 App 再將其繪出, 減輕工程師初期的工作負擔, 得到圖形化的效果
- 同上, 使用類似 arduino 版子的其它平台, 如 LinkIt ONE(連發科 IoT 平台)
- 使用藍牙連線配合手機移動性較佳, 較省電, 更不需要 WiFi 環境
- 圖片波形為測量溫度計之實況
- 如不需要提醒功能, 只要將設定值設為 999即可(任何> 100的數目字)
- 每筆資料大概間格 100ms 送出, 一秒大概 9筆資料送至App, X軸每筆資料間格 5pixel0, Y 軸資料間格 2pixel
如果接收的資料有誤 或是 漏接(原因很多不詳述) 皆跳過不畫出 This App is a gadget for the following projects occasions:
- Double A project (Arduino + Android)
  arduino end when the sensing end (temperature, humidity, pressure, etc.) and then the raw data into 0 ~ 100 data via Bluetooth to the Android terminal module,
  Then this App which plots, reduce the workload of the early engineers give graphical effects
- Ibid., Using a similar arduino version of the child's other platforms, such as LinkIt ONE (bursts Division IoT platform)
- Use a Bluetooth connection with mobile phone better, more energy, but does not require WiFi environment
- Picture for live waveform measurement thermometer
- Do not need reminders as long as the setpoint can be set to 999 (any> number of 100 words)
- Information about each compartment 100ms sent, one second about 9 strokes information to the App, the X-axis between each data cell 5pixel0, between the Y-axis data grid 2pixel
  If the received information is wrong or miss (many reasons not described in detail) are skipped Draw